# Path to the voltage table sysfs interface file 
# The init script will detect which one of the 2 below file exists and use the correspond table 
VTABLE_PATH_0_2_X="/sys/devices/system/cpu/cpu0/cpufreq/op_points_table"
VTABLE_PATH_0_3_X="/sys/devices/system/cpu/cpu0/cpufreq/phc_controls"
VTABLE_PATH_0_4_X="/sys/devices/system/cpu/cpu0/cpufreq/phc_vids"

# Switch back to DEFAULT_VTABLE if undervoltage is stopped? [yes/no]
SWITCH_BACK="yes"

# Default voltages that will be restored at shutdown if SWITCH_BACK=yes
# Linux PHC 0.2.x uses a table of Frequency:Voltage pairs
# Linux PHC 0.3.x uses a table of FID:VID pairs
DEFAULT_VTABLE_0_2_X="1600000:1340,1600000:1340,1600000:1340,1600000:1340,1600000:1340,1400000:1276,1200000:1212,1000000:1132,800000:1068,600000:988"
DEFAULT_VTABLE_0_3_X="16:40 14:36 12:32 10:27 8:23 6:18"
DEFAULT_VTABLE_0_4_X="40 36 32 27 23 18"

# Custom voltages that will be applied at boot time
CUSTOM_VTABLE_0_2_X="1600000:972,1600000:972,1600000:972,1600000:972,1600000:972,1400000:908,1200000:844,1000000:764,800000:700,600000:700"

# rounding error at 16:16, 14:11, 12:6, 10:2
CUSTOM_VTABLE_0_3_X="16:18 14:13 12:8 10:4 8:0 6:0"

CUSTOM_VTABLE_0_4_X="18 13 8 4 0 0"

# Set the following to "yes" when the all the settings are configured
# This is a safety to disable setting the voltages with the default
# values of this file that are probably wrong for your CPU 
IS_CONFIGURED="yes"